DCA Mini Sabre Vanes

Description

Engineered through two years of testing and refinement, the Mini Sabre Vanes redefine vane performance and precision. Each vane is individually molded using an advanced 8-cavity system to ensure exact uniformity, delivering a consistent 6.0 ± 0.1 grain weight across every set. That means tighter tolerances, better flight control, and unmatched accuracy shot after shot. Built from the same ultra-tough material used on golf balls, the Mini Sabre is designed to flex, take impact, and return to shape without fail, even after pass-throughs on targets. Pair them with the Sabre Primer Pen and Bob Smith Maxi-Cure adhesive for an almost permanent bond that stands up to any condition. Scientifically developed using Computational Fluid Dynamics (CFD), NASA stability modeling, a custom wind tunnel, and LabRadar (Doppler radar) testing, the Mini Sabre delivers superior aerodynamics and flight stability. The result is a vane that’s tough, precise, and built to dominate in any hunting or target scenario.

Specs

Weight	6.0 +/- 0.1 grains
Height	.465"
Length	2"

Application

1. Clean the shaft by wiping the arrow shaft or wrap with a clean, dry paper towel. Avoid using acetone.
2. Place the Sabre vane in your fletching jig clamp. A 2.5° helical (left or right) is a great starting point but not required
3.  Use the Sabre Primer Pen to prepare the vane base for a strong, long-lasting bond
   
4. Add a thin, continuous bead of Maxi-Cure glue along the vane base. Do not spread it out
   
5. Press the vane firmly onto the shaft and hold for about 10 seconds (or per adhesive instructions)
6.  Release the clamp and wipe away any extra glue from around the vane base
7. Allow the adhesive to fully cure for 10–15 minutes before handling or shooting